Needed Tools

Needed Tools

The number of tools required for building a stitch-and-glue boat is relatively small. Most of the tools are hand held and readily available at your better hardware stores. Below are the tools that I acquired for this project.


  • Makita Sander Polisher 9217 SPC
    • 3M 8-inch soft backing pad part # 05568
    • 80 and 150 grit Stickit discs
  • DeWalt Router 610
    • Chamfer bit
    • Roundover bit
  • Stanley Block Plane
  • Jigsaw
  • Makita Circular Saw
  • Gougeon Brothers Scarffer Attachment
  • Cordless Drill, Drill Bits, Countersinks
  • Vibrating Sander
  • Shop Vacuum
  • Hammer
  • Pliers
  • 16 Gauge Bailing Wire
  • Wire Cutters
  • Tape Measure
  • 48 inch Tee Square
  • 9 foot straight edge
  • Square
  • Plumb Bob
  • Line Level
  • Compass
  • Bevel Gauge
  • Respirator
  • Safety Glasses
  • Scissors
  • Propane Torch
  • Screwdrivers
  • C Clamps
  • Stanley Sure Form
  • Epoxy Accessories
    • Tongue Depressors (to stir with)
    • Autobody Plastic Squeegees
    • Graduated Plastic Mixing Cups
    • Epoxy Dispensing Pumps
    • 2 inch Cheap Paint Brushes
    • Roller and Foam Pads
    • Aluminum Epoxy Roller
Author
Eric Patterson
Views
121
First release
Last update
Rating
0.00 star(s) 0 ratings

More resources from Eric Patterson

Back
Top