Search results

Bruce, have you looked at the new 17' duck boss. I just got the 13' duck boss, well built, clean and rides great. www.duckbossboats.com

This does not sound duck related to me, how about checking on the ford,chevy and toyota forums.

TTT

Scott, the correct fuelhose for most yamaha's under 70hp is 5/16 inside diameter. The outside diameter does not matter.

Has anyone tried running there navigation lights with a 14volt rechargable power tool battery?

benelli super blak eagle 1 or 2

Thanks Pete

Pettit Paint or Parker duck boat paints. Has anyone tried one or the other and switched, durability between the 2. Need to repaint duck boat, has parker paint on now, thinking of switching to pettit.

Nice bird, shot my first NJ turkey this morning, not as nice as your but a good start to the season with a few weeks still left. It has been wet here as well most of this spring.

It ran the best the 2nd location out from the transom.

Scott, I ran a 9 1/4 + 9 on mine because of the weight I ran in the boat. With just myself in the boat planned off real quick and the rpm's stayed up. Run it first but if you feel the boat does not plain off real quick try the smaller pitch, you will lose a little top speed but the boat will...

Thanks Jim

Scott, what pitch prop does your motor have? These huff boats are fast in the water. If your under propped your going to hit the rev limiter real quick. Do you plan on hunting more than 1 person in the boat?

The closest to the transom.

Will the penetrol cause the paint to have a sheen to it or will it still dry to a flat finish?

I have had to do this on 3 diffrent boats that I've owned in the past and the same to a couple of friends boats. Most of them switched from johnsons which has a wider mounting clamp than the yamaha. If you call mlb tomorrow James Stoney will explain it to you. From what I have heard the newest...

Scott, I had to trim mine about 1/4 inch to get the yamaha to clear. I marked a line across the top and taped everything around off in case I slipped, used a grinder to trim the bulk off and then sanded it down the rest by hand. After I fit the motor i reglassed with resin over the grinded area...

Thanks for the info Jim

Do you know if it can be sprayed with air spray gun, do they have a special thinner?

I agree, the less holes you have in the boat the better. There are alot of cable holders available to run the cable over the transom and hold it in place and they look neet as well. If the transducer hits something in the water and pops loose of the mounting bracket, it could put enough stress...