Canvas Cockpit Cover for RED-LEG

Steve Sanford

Well-known member
All~

Amongst all of my on-going projects, I finally got a couple of hours to sew a cockpit cover for my own Sneakbox RED-LEG.

I made a hard cover (hatch) earlier this year - but it is intended only for off-season storage.


Hatch%2003_zpsayhcdywn.jpg



Once the boat is thatched, a hard cover cannot fit over the coamings. I have long used canvas covers that get lashed to the thatch rails. It protects the grass but also "adjusts" to worn grass, snow, et cetera. And, a canvas cockpit cover is stowed aboard - so it is with me if I need it - for sleeping aboard or keeping windward seas out of the cockpit - when I am out on the bay.


The canvas is shaped to follow the curves of the coamings and thatch rails - and is about a foot longer than the cockpit on each end. This is Tresco Birch Marine Sunbrella - from sailrite.com


RL%20cover%2001_zpsctzj0gc4.jpg



Five grommets (half-inch inside diameter) on each side take short lengths of decoy line.


RL%20cover%2002_zpsjbo5yyee.jpg




The white arrow tells me which ends goes forward in low light conditions.



RL%20cover%2003_zpsl9wuyqed.jpg



RL%20cover%2004_zpsvw7qpe3d.jpg




My Push Pole serves as a ridge pole.


RL%20cover%2006_zpsi5fry5tp.jpg



A "slipped square knot" - like tying your shoe with a single bow remaining - allows the line to be easily freed with a single tug on the free end. I have never had one fail - even with lots of trailering at highway speeds.


RL%20cover%2005_zpsjoka7mc2.jpg



The "lump" on the stern deck is caused by the rolled-up "lap cover" which stows there when not gunning.


RL%20cover%2007c_zpskl7qkhuk.jpg



All the best,

SJS

 
Last edited:
Back
Top