Eric

B Reilly

B Reilly

New member
Here's the set up I told you I was picking up. Turns out I can't use the parts I bought it for. So watch for it on OWWM. Either all together or in parts. You need anything off of Delta/homecraft?
toolhomecraft.jpg

 
Bob

I wish that disk sander would fit my Oliver but the bed gap is different. Are you selling the whole thing? That's a noce little setup for someone who wants a workshop but has little space. I suspect it will go fast on owwm.

Thanks.
 
That sanding table is going on my delta lathe LOL I'm pretty sure I'm going to sell everything but the sander table. I have a line on an old parks planer. I can use that ! LOL
But it's a great little setup for the corner of a garage/shed. If my sheds weren't filled with drying wood I might keep it .
 
Bob

You know that would be a dandy of a call turning setup. You could cut stock to turning blanks with the tablesaw, set the jointer to 45 degrees, and take the corners off. The lathe would be really nice for call-sized turnings. You could even cut out call inserts with a jig and the scrollsaw.

When you get the Parks let me know. I restored one from the ground up. It flat out SPANKS porta potty planers.
 
You must log in or register to reply here.
Back
Top