Made a lil progress on the Duck Sneak

[Chris Riggs]

Finally got a lil time to get in the shop and work on my next project, it had a few cracks and holes in it and most of the floor was gone, so a little cutting and a lot of sanding, I patched the cracks and holes with Bondo and a few coats of Glass on the outside, then 2 layers of mating, and glass on the inside of the hull, so I'm sure it wont leak now, got to get started on the floor , I think I'm just going to put a piece of foam board in the bottom and glass 1/4 plywood over it for the floor, then look round for some kind of seat to put it the bottom , I think it will make a great little boat to pull behind me with my gear and one of the kids to ride in, while I wade in to spots.

 

[Chris Riggs]

Got some time off from work and spent it finnishing up the duck sneak, I added 2 pieces of foam insulating to the floor and then cut 1/4 plywood to fit, glassed it in then painted the outside I went back after it all was dry and put indoor outdoor carpet over the inside, Floated tested it sunday and it handles like a dream. cann't wait till next season to float the creeks round here.

 

[DeWayne Knight]

Chris, I'd like to see a couple more photos from the side if possible. I'm trying to imagine the whole boat and the pictures you posted don't help my feeble imagination enough...lol.

 

[Chris Riggs]

Here's a few of the boat when I got it home and the only one finnished that I didn't post before hope that helps Dewayne