Recent content by JAMES ROBERTS

Been out for a while.. Whats the status on the tee shirts? James Roberts

The two happiest days of the year. Opening day and closing day! James Roberts

Boys under drawers with hole cut for tail, a pantie shield taped in place works great. Lot cheaper than store bought protection. Looks cool if use underoos!! James Roberts

I thought the kara was too heavy so I designed and built by own 11.5 ft by 46 in. The transom is 13.5 in. high. The boat after a put a cedar floor in weighs 95 lbs. I have run 2.5 horse and 6.5 horse mud motors with great times had by all (Dog and Me). James Roberts

Oh my will I have to mark all my lead shot?? Hee Hee! That is what I will use If I am going to shoot someone. Of course they would be a uninvited guest in my home. These are the same people that think crack should be legal. Wait a sec if crack is not legal and who knows how many people use...

This is off the beaten path. I buy shells by the pallet from Max's never been a problem there. Three years ago I found a wally world end of season sell. I bought 6 cases of a major brand of steel. Those shells caused the same problems that everyone is talking about in two m1's and a sbe. The...

I had a 90 horse power head jet drive that equaled 65 horses. Underpowered loud screaming sun of a gun. It was always getting stopped up with leaves sand weeds you name it. It would over heat in the sandy bottoms. Never broke a lower unit off the jet drive is about all I can say good about...

Matt Can you explain (scored). A good gunsmith can hone a few thousands out no problem. If your talking about groves from the steel shoot coming out of the protective cup early, I would not give that a second thought. I have a 870 that looks almost rifled. When steel first come out on the...

jaw coupling. Cheap and seem to hold up in the limited testing I have done so far. I can tell if the drive shaft has migrated toward the motor shaft. Jaw couplings are about 10% the cost of a u joint. The marsh boat I built has a 14 inch transom which eliminated the need for the mm to have...

Small world!! I was testing the 6.5 mm out at rogers point. I live about a mile from where you saw me. Do you live in Claremore? I'll post some pic's later to night. James Roberts

[inline jse_CIMG0859.jpg][inline jse_CIMG0859.jpg]The boat is of my own design. 11.5 ft long, 46 inches wide, weighs 90 lbs. Light enough to carry in a little way. It can ride in the back of the truck or inside my 19 ft rough neck. Sometimes I put it on my broadbill trailer and tow it with...

Just put this one together today. 6.5 horse weighing in at 46 lbs. Test runs in the morning! In the back ground was my first one made this summer a 2.5 horse weighing in at 40 lbs. Aluminum frame cut a lot of weight. I plan on redoing the 2.5 in aluminum this spring. It should be in the 26...

Ordered prop on Monday got the prop Thursday! Hopkins propellers you can't beat that for service. Mean while Hill marine has not sent me a thing But keeps saying "we'll send it out this week". Hmm 9 weeks and counting. James Roberts

Thanks Capt. Talked to Glenn last night they are setting the pitch,and cutting the dia. as I type. James

Where does everybody get there mud motor props? James Roberts