Recent content by Matthias

I went through the entire shelf of mouldings and chose the best ones. Initially when I first glued on the moulding I had planned on it being the first of two laminations, but now I reckon it will suffice on its own, covered with two layers of tape and then a strip of HDPE over the top as the rub...

All good, sarcasm understood (y) So far I feel all screws have not been a problem: they are decently countersunk into the ply and then filled over. Most are under glass as well. Its the upcoming fittings and hardware that requires bolts that worries me. I'll make sure I have good oversize holes...

Very briefly, so we don't clog up Henry's thread... Thank you both, this is excellent, valuable info. The deck plates I'll endeavour to keep clean, and the stringer below them should act as the perfect support with a bit of a spacer. I'll monitor all the sealed chambers for moisture as best I...

We were expecting a couple of big jobs at work and the thoroughfare where I was building needed to be cleared -- so the boat had to move! This was a bit of a concern since the bulkheads two and three had not been filleted and the chine stitching was not super tight. It was necessary to have all...