Richard Lathrop

Needs some work. https://www.facebook.com/marketplace/item/1337844101618094/ Rick

^^^This is hard^^^, but over time you begin to understand that being in the right place at the right time to end their life with dignity...

Steve, https://www.ducks.org/conservation/waterfowl-research-science/a-birds-eye-view Rick Lathrop

Congratulations on your retirement!

@HenryHawthorne you are correct . We had a dog come in the other night… case was so bad I wound up calling animal control on those...

Steve, Great write up. It did make me read an article on mallard vision out of curiosity. Would the details matter to a mallard you...

Good morning, Eric~ Helpful information - of course! I was surprised to learn of your bad experience (head shearing) with rolled...

I am compelled to add a few things I've learned over the years. First, I avoid rolled thread screws if strength is important. Rolled...

According to Google AI, it is in Chapter 8 under planking. Rick Lathrop

Richard~ I'll bet I read those words many decades ago - and this ol' noggin can no longer "access" them. Thanks for the reminder...

Howard Chapelle’s advice ‘was nail where you can, screw where you must’ It is economics and fact that these boats were considered...

Steve, I used a hex bit adapter from Lee Valley Tools and a Yankee screwdriver when installing square drive screws on my sneakbox...

I use silicon bronze square drive boatbuilding screws from McFeelys https://www.mcfeelys.com/search/?q=silicon%20bronze%20boat I have...

Capt Bob, What is the pipe out of the rear of the box for? Is the harpin rotted? Looks like it was glassed at one point. Rick