Richard Lathrop

Dave Below are just a few of the YT videos I found that show a similar set-up to what we've been discussing. They all use more...

Hi there, greetings from Sydney, Australia. Google led me here, well actually to Henry’s 2025 Devlin Snow Goose build thread, while I...

Good Evening, I’ve been a member for a while and lurked on and off. This site seems like the best resource for information on small...

Hello, I haven’t posted much. But I started reading through the forum when looking up specifics about decoy carving and boat maintenance...

Nice mix of sneakboxes and gunning garveys in that photo

Bob, Was this boat used to tow other sneakboxes? Rick

This is a 1940 22ft inboard sneakbox built by Ed Cranmer of Cedar Run NJ. It had a 7 1/2 ft beam and was powered by a 4 cylinder...

Not a project but this Simonsen sneakbox has been for sale for awhile...

Quick day trip with my bride today up to Lake Mattamuskeet. This is a place both of our dad's used to duck hunt (didn't know each...

Thank you and yea you know your by a cedar and pines when the water looks like rootbeer i dont think i could ever leave it

Nice boat. You know you are in the Pine Barrens when the water is brown. Miss seeing the cedar water. Rick Lathrop

Here is my 1984 10ft Gunning/ Sailing garvey built by Mark Ford. He built 3 of them 2 just for Gunning and 1 as a gunner/sailor. It...

Well after almost 2 years it is time to add a new hunting partner. I will be picking up this little guy the end of the month. Been a...

What is the final turned diameter? Tangental cut means 1 7/8" minus diameter to get height of the cutting edge of tool above cross slide...

http://www.vintagemachinery.org/pubs/detail.aspx?id=13914 Pages 10 and 11