SJ Fairbank

Just starting to pick away at the trout. Got in a north country trip to a remote lake last weekend. Literally spitting distance from...

I promise this is my last response to this thread. I won't argue with your points on the client mix. Nobody is seriously arguing...

Adam, I don’t want to drag this out, but I keep coming back to the same concern. These regulations put most of the pressure on...

I was able to get a good supply of cypress from a local lumberyard. The decoy factory has since been in full production.

I'm doing some detail painting on the heads of some of these carved synthetic tupelo decoys my son painted for me over the past weekend.

Steve- The traditionalist in me would advise use of silicon bronze slotted screws and Brace to fasten them. Nowadays I’d go with a...

I've been thinking about how to discuss this further, and I could go on forever. I'll keep it relatively short to avoid being a serious...

My thinking is to use screws, all pre-drilled and countersunk. I wouldn't want to pound nails on an older boat for fear of cracking a...

Today I had a very good conversation with Ryan Barnes, Editor in Chief of Wildfowl magazine and I directed him to this thread. My...

I’ve followed this thread for a while and mostly stayed out of it, but I guess I’ll finally weigh in. I’ve hunted the prairie provinces...

That's a stout effort! I always enjoy your doodles. Thanks for keeping it going.

That confirms much of what we discussed regarding how they came to enact the regulations. Thanks for posting.

What Henry said. If you decrease the pressure more than 10%-15% below maximum you can expect accelerated tire wear with more likelihood...

Your tire is designed to be run at the higher pressures. Fill it up. Generally speaking, trailer tires need to be run at/near capacity...

Ah. Derp. All those northeastern states are so little I just presumed Plum Island, New York was no more than twenty minutes from any of...