Jeff Reardon

I can't relate as a duck hunter. My "home" early season spot hunts best in low water years, when it's puddle duck magnet. In normal and...

Those look workable--and a lot smaller diameter and cheaper than the ones sold as climbing hardware.

Thanks, all. One final question on the Tapcons or other hardware. Is anyone aware of a an anchoring system that can be driven into a...

,Mount one on your pond box . . . . .

Tapcons like these? Are those just galvanized steel? Can they really be screwed or hammered into solid rock? Most of my sites will be...

Too many of my sites are ledge--or very large boulder fields. On smaller streams I have cabled or chained to trees on shore or downed...

Any experience with JB water weld for bonding? Seems to be their only product that will set if submerged, and it should be easy to...

Stainless steel eyed lag bolts at 1/4"4", or 5/16", 3". $3-4 each. That gets me to a small and relatively short hole to drill. Now I...

Don't know where they came from, but there were a couple of sneak boxes in the lobby at the National Conservation Training Center, a US...

How big are they? Never seen them except here and other places online, but they look good, and appear not to have the tailboards that...

But you've got Indian Hill Trading Post when you are up here. If you can't get it there, you don't need it!

However, research suggests all I need is a cordless hammer drill with a long enough masonry bit, and I think I can find those at a cost...

Used to be. Next town to mine was a granite quarrying hot spot--supplied the granite for the Brooklyn Bridge, among many other famous...

Nope, not talking about boat anchors. I put up a post a couple of months back about underwater epoxy. Research to date talking to...

Pretty sure PA still doesn't allow any electronic attractant, which I'd like to see continent wide. But since that's not the case...